The module CW-301 makes it possible to switch power relays by means of CAN messages and manual switches. As a consequence, it is possible, for example, to switch on the power supply to mobile measuring equipment by means of a specific CAN bus signal (e.g., KL15) or charge batteries installed in measurement technology to defined vehicle states.
The CW-301 is equipped with three switchable outputs and can be operated with a maximum switching current of 30 A. 10 A thermal circuit breakers protect the manual and CAN controlled circuits.
It is possible to configure a wide range of different settings via the CAN protocol, such as the baud rate, CAN message, sleep mode and follow-on time.
| Number: | 3 |
| Nominal voltage: | 12 VDC or 24 VDC |
| Switching current: | 10 A per voltage output (protection though thermal circuit breaker) |
| Switching power max. | 120 W per channel at 12 VDC |
| Switching cycles: | ≥ 100.000 |
| Response time / fall time: | ≤ 10 ms (at 20 °C) |
| Connector: | Socket for 4mm connector (banana jack) |
| Number: | 1 |
| Type: | ISO 11898-2 (highspeed) CAN-protocol version 2.0 A and 2.0 B, supports SAE J1939 (29-bit-identifier) |
| Data rate: | 50, 100, 125, 250, 500, 800 and 1000 kBit/s configurable via CAN-bus |
| Termination: | 120 Ohm, optional |
| Connector: | D-Sub9-connector |
| Supply voltage: | 9 to 30 VDC |
| Current consumption: | 30 mA at 12 VDC (unswitched) 510 mA at 12 VDC (switched on, without load current) |
| Connector: | LEMO ECG.3B.302 |
| Temperature range operation: | -20 °C to +70 °C |
| Temperature range storage: | -20 °C to +85 °C |
| Relative humidity: | 35 % to 85 % non-condensing |
| Protection class: | IP40 |
| Housing: | HF-Tubus |
| Dimensions (LxWxH): | 71 mm x 131 mm x 171 mm |
| Weight: | 1.100 g |
Back to the overview | CW-300 Series
